Cupid’s Delight

Cupid’s Delight

This cake may look very involved but really it is not hard to do and is not difficult to set up either.
Cake sizes are all two-layer - 2 of each: 6, 8, 10, 14 with (2) side 10-inch cakes and (1) center 10-inch cake - Serves 528

NEEDED

ACRYLIC TUBE shown no longer sold (for under fountain) You’ll need to dowel the 12-inch cake and use a separator plate to keep the fountain level
(4) STAIRWAYS and 1 BRIDGE
16 CUPID PILLARS no longer sold
SEPARATOR PLATES: 4 of 8-inch, 4 of 10-inch and 1-8-inch for under the fountain
GARDEN TRELLIS
BRIDESMAIDS, USHERS
BRIDAL COUPLE
BUTTERCREAM ICING ROSES or... Other Flowers
CAKE FOUNTAIN

TO SETUP:
Place the 12-inch cake in the center.
Setup the side - 2 tall cakes with pillars between.
Attach the bridge to the 2 stairways. Try the stairways. Slide cakes closer if necessary.
Note that stairways rest on the SIDES of the top cakes using this setup, not on the tops of them.

For the 2 outer cakes with stairways, place cakes on the table and add the stairways as shown.
Add the garden trellis the bridge. Attach bridesmaids and ushers with dabs of icing underneath them.
Place the fountain on the Plexiglas tube and fill with water.