Make one for each
blossom and when dry, attach with a dab of icing
to back to produce a small flower with a long fluted
shape. Dry and prepare to assemble

Assemble flower:

Position one blossom at top of a length of heavy weight green
florist's wire pushed into a styrofoam block. Use green
florist's tape to bind it in a position as shown. Then tape
another blossom, letting step extend about 1/4-inch from
main stem. Continue to tape on blossoms in this manner, going
around and around, and allowing some air between
blossoms to give the natural "see-through" appearance of the
flower, until a long oval shape is achieved. (Wind in top and
bottom blossoms closer to stem to taper flower) Wind tail
of tape around main stem to bottom to finish off.